Yamaha Blaster MasterFlow Intake Manifold

Yamaha Blaster MasterFlow Intake Manifold

89.95
* NOTE: Masterflow intakes are built to work with stock reed cages. If using alternative brand of reed cage *Contact DRI.
A special masterflow intake may be required.

Purchase Options
Part # DR-3234 MasterFlow Intake Manifold System (34mm-35mm) $89.95
Part # DR-3226 MasterFlow Intake Manifold System (26mm-stock) $89.00

Replacement Parts
Part # DR-MFFG-34 Replacement rubber flange $24.95

The use of MasterFlow intake manifold system and Pyramid Reed Valves is required to maximum performance out of larger after market carburetor

Designed to work properly with larger carburetors. Stock intake manifolds are not designed to accept larger carburetors. If larger carburetors are force feed into stock manifolds they will split causing an air leak and engine failure.

Throat on stock manifolds are way to small to allow larger carburetors to perform properly

Not only does MasterFlow flange offer proper fit, but throat of manifold is designed for larger carburetors

Removeable Rev plate enhances low end power, but must be removed for use with PYRAMID Reed Vlaves

System also available with Rubber mounting flanges for stock carburetors. If purchased in this configuration, flanges may be replaced with 34mm-35mm models

MasterFlow performs best with PYRAMID Reed Vlaves
The use of MasterFlow intake manifold system and Pyramid Reed Valves is required to maximum performance out of larger after market carburetor
masterflow-yfs-34.jpg





masterflow-yfs-34.jpg
dr.gif
Blaster MasterFlow Intake Manifold





sold out
Add To Cart